doseBadge Personal Noise Dosemeter Helmet Mount

The doseBadge Noise Dosimeter is traditionally mounted onto the shoulder of the person whose noise exposure will be measured.

However, there may be situations where this is either not possible or where mounting the instrument onto a hard hat or helmet may be more suitable. For example, the type of clothing that the person is wearing may not be suitable for mounting the doseBadge via the supplied clips.

A set of mountings are available for the doseBadge Personal Noise Dosimeter that allows the unit to be mounted onto a helmet. The mount uses a version of the clip that is usually used to attach hearing protection to a helmet and can be mounted on either side of the helmet.

Please note that if the CM:100 Helmet Mount is fitted, hearing protection cannot be attached to the helmet.

CM:100 doseBadge Helmet Mount for the CR:110A doseBadge Noise Dosimeter

Versions & Ordering Information

There are three different types of helmet  mount available for the doseBadge and these suit a range of different manufacturers products.

The most commonly used version is the CM:100/E which is suitable for a certain helmets from manufacturers such as MSA and Peltor.

Below is a list of the available CM:100  mounts and examples of compatible helmets.

InstrumentDescriptionPTB Type ApprovalLNE Type ApprovalApplus+ Type Approval
CR:161AClass 1 Integrating Sound Level MeterYesYesYes
CR:161BClass 1 Integrating Sound Level Meter with data loggingYesYesYes
CR:161CClass 1 Integrating Sound Level Meter with 1:1 octave band filters & data loggingYesYesYes

Please note that Cirrus Research cannot guarantee that the CM:100 helmet mounts are suitable for all helmets, and we cannot provide information about specific helmets and compatibility with the CM:100 mounts.

For more information, please contact Cirrus Research or your local distributor.

 

Jaymee-lee Tolliday

Marketing Executive at Cirrus Research plc

Latest posts by Jaymee-lee Tolliday (see all)